SkyTrak 6042 Operation Manual - Manual (Page 170)

168 Model 6042 Origin 5/02
Test Procedures
Test Procedures
To test the function of the Stabil-TRAK system, read the Stabil-TRAK
system test instructions on this page and follow steps 1 thru 9 of the “Stabil-
TRAK System Test Procedures” starting on page 169.
Stabil-TRAK System Test Instructions
• Test the Stabil-TRAK system with the vehicle on a level surface.
• Remove any attachment from the quick attach before performing
the test.
• DO NOT extend the boom at any time during the test. Perform the
test with the boom fully retracted.
• DO NOT raise the boom above 60° for steps 3 thru 6.
• DO NOT raise the boom above 45° for steps 7 thru 9.
• Follow steps 1 thru 9 of the Stabil-TRAK system test procedure
exactly as written.
If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground
at any time during steps 4 thru 7, the test was not performed properly or the
Stabil-TRAK system is not functioning properly. Carefully repeat the steps
starting with step 1.
If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground
consistently during steps 4 thru 7, the Stabil-TRAK system is not functioning
properly and the test should be stopped immediately. Contact your
OmniQuip Authorized Service Center (ASC) immediately to repair the
system.
Stabil-TRAK System Test