SkyTrak 6042 Operation Manual - Manual (Page 145)

General Maintenance
143 Model 6042 Origin 5/02
Figure 94
B. Rear Axle
1. Working through the level plug hole (Figure 93, 1), carefully use a
screwdriver to spread the brake disks apart.
IMPORTANT! DO NOT damage the surfaces of the brake disks when
spreading the brake disks.
2. Using a feeler gauge, check the gap (Figure 94, 1) between the
brake disks (2). If the gap is greater than .167" (4,25 mm), replace
the brake disks.
NOTE: If the brake disks are worn beyond .167" (4,25 mm), the brake disk
must be replaced on both sides of the axle at the same time.
3. Repeat step 1 and step 2 for the other side of the axle.
4. Continue with step 6 of “B. Axle Oil Change” on page 139.
MT2840
1
2