Defi Link Meter - Manual (Page 5)

58
(more than 30A) will not blowout even with an abnormal current flow
and may cause fire.
●This product is for use ONLY on vehicles with a 12V electrical
system. NEVER use the product on 24V vehicles.
●Use only the wires provided. If additional wires are required, use the
same of quality and gauge wire as is provided with the kit.
●Insulate any unused wires. If any wires or connectors loosen during
installation, please make sure they are correctly reattached.
●Dropping any of the components of this product will result in damage
to the product.
●Excessive force on switches/terminals may result in damage to the product.
●Do not attach wires on the body of the vehicle or engine parts as this
may result in damage to the product.
●Install sensors away from heat and moisture to avoid damage.
●Do not pull away the wire.
●Install sensors away from ignition and also radio signal frequency
interference as this could cause the gauges to malfunction.
●Do not wire the sensor wires near the engine, exhaust pipe or turbine.
It may result in damage or fusion of wires.
●Do not expose control unit to moisture, dust or direct sunlight, or
place product directly in front of heat vents.
●Make sure the waterproof processing is done when diverging wires in
the engine compartment.
●Wear gloves so as not to get burnt when soldering.
●If the negative battery terminal is disconnected, audio and clock
memory data may be lost. The necessary data will have to be re-set
after installation.
CAUTION