Defi Link Meter - Manual (Page 39)

92
1.Insert the convex part of the mounting bracket over the legs of the meter
cup. Attach the mounting bracket to the meter cup with the nuts and
bolts included with the kit as shown in figure 1. (Do not fasten tightly.)
2.Fasten the tapping screws where you intend to attach the meter.
3.Fasten the meter cup in the proper direction and fasten the M6 bolt.
4.Attach the buffers all around the meter(front and rear) as shown in figure
2.
5.Pass the meter wire through the hole of the meter cup and connect it to
the meter.
6.Place the meter in the meter cup making sure that the wire is not
sandwiched.
7.Fasten the bolt for the meter cup from the back side of the meter cup.
・The red triangle can be used as an warning indicator.
・To move the position of the red triangle,
remove the bezel once and then attach it again.
・Some kinds of meter hoods and visor cannot be
installed in combination with the bezel. (Refer to P.67)
(C) 115mm meter
(B) Bezel (52mm and 60mm meter)
Buffer 【figure 1】 【figure 2】
Bolt for Meter cup