Defi Link Meter - Manual (Page 42)

95
○Ensure that all hoses and tubing are permanently attached.
Also ensure that there is no leakage of oil, fuel, water and exhaust.
○Check that the sensor and wires are not interfering with the engine.
○Ensure that devices associated with the ignition（ie. ignition coil,
distributor, plug cord, etc.） were not damaged or disconnected during the
installation of the sensor and wires.
○Ensure that the gauge and wires are tightly attached, so they don't come
loose and hinder driving.
○Check that all wires disconnected from the vehicle during installation have
been properly reattached.
○Ensure that the negative battery terminal is tightly attached. Close the
hood properly.
This concludes the installation process.
●FINAL CONFIRMATION AFTER INSTALLATION(for installation personnel)
●Please be sure to check the following items. Otherwise, there is a possibility that a
serious accident may occur.
WARNING
●After installation, check that no materials or tools remain in the driver’s seat or
the engine compartment. If there are tools at the feet of the driver’s seat, this
may cause brake operation failure because of tools or materials caught under the
brake pedal. If there are tools in the engine compartment, the engine may break
WARNING