Defi Link Meter - Manual (Page 31)

84
WATER TEMP.
Use a commercial sensor attachment
Upper hose
Radiator
Sensor attachment
(commercially available)
＊Cut the upper hose and connect
the sensor attachment between
hoses.
Attach tightly with clamps.
（commercially available）
To sensor wire←
●Be sure the sensor wire is not twisted when installing the sensor. The sensor wire
will be cut.
●The thread size of the temperature sensor is 1/8PT. If the thread size of the sensor
attachment for the temperature sensor is 1/8NPT, you will need the 1/8NPT
temperature sensor (optional part).
●Tighten the sensor into the sensor attachment and then connect it to the sensor wire.
Wind Teflon tape.
Thread size 1/8PT
Sensor
Be sure not to twist.
●To avoid water leaks during installation of the sensors, use teflon tape. Attach the
T-joint and upper hose with a T-Bolt clamp. Inspect hose connections for leaks
before driving.
●Coolant spills by the installation work. Please replenish the engine with coolant
and bleed the air from the system, or the engine might overheat.
●To avoid the damage of sensor wire, please fix the waterproof connector on the
vehicle body.
CONFIRMATION
WARNING