Defi Link Meter - Manual (Page 36)

89
● WIRING THE CONTROL UNIT Ⅱ(for installation personnel)
○HOW TO USE THE SOLDERLESS CONNECTOR
（1）Strip off the outer
wire insulating
（2）Wind to fasten
the peeled wire
（3）Solder this part, making
sure it is spread property
（4）Wrap tightly with
vinyl tape
○HOW TO SOLDER
Power supply wire
vehicle side
power
wire
(red)
battery
power
wire
(white)
illumination
power
wire
(orange)
IGN
power
wire
(black)
GND
wire from
vehicle
Insert wire
up to
this point.
cable to gauge
vehicle side
Press until a clicking
sound is heard.
Red : Battery
(To 12V battery wire)
Orange : IGN
(To 12V wire when ignition on)
White : Illumination
(To 12V wire when small lamp is on)
Black : GND
(To ground, negative battery terminal)
CONFIRMATION
●Wear gloves so as not to get burnt when soldering.
●When connecting wires by soldering, wire thoroughly not to cause poor contact.