Warning, Exhaust temp – Defi Link Meter User Manual
Page 33
86
EXHAUST TEMP.
Exhaust manifold
Attach here.
Fitting（1/8PT）
（1/8NPT Fitting is an optional part.）
Sensor
Sensor wire
2 pin plug
→
To
Control
Unit Ⅱ
1.Dismantle the sensor fitting（making sure not to crush the bushing inside
the fitting）
. Attach the sensor fitting at the point where the screw threw
thread is hashed using the 1/8PT tap.
2.Pass the sensor through the bushing and fitting nut and attach the
sensor fitting to the exhaust manifold. Adjust the end of the sensor fitting
（5 to 20mm, 1/5 to 4/5"）so that it will be positioned in the center of the
exhaust pipe to which it is attached.
●When making holes to install the sensor, be careful that metal chips do not get
inside of the exhaust pipe or turbine.
It may result in damage to the engine, exhaust pipe or turbine.
WARNING