Defi Link Meter - Manual (Page 29)

82
OIL PRESS.
Use a commercial sensor attachment
●Be sure the sensor wire is not twisted when installing the sensor. The sensor wire
will be cut.
●The thread size of the pressure sensor is 1/8PT. If the thread size of the sensor
attachment for the pressure sensor is 1/8NPT, you will need the 1/8NPT / PT
conversion socket(optional part). If it is neither 1/8PT nor 1/8NPT, you will need
to purchase a conversion adapter available from hardware stores.
●Tighten the sensor into the sensor attachment and then connect it to the sensor
wire.
CONFIRMATION
WARNING
●To avoid oil leaks during installation of the sensors, use Teflon tape. Before driving,
inspect tubing and oil blocks for leaks. Leaks could cause a fire or damage the
engine.
●Oil spills by the installation work. Please replenish the engine with oil. The engine
might overheat when oil is too little.
●To avoid the damage of sensor wire, please fix the waterproof connector on the
vehicle body.
●Do not attach the pressure sensor to the place where the genuine pressure switch
is attached in the case it is attached to the oil pump body of the vehicle. The
pressure sensor might be broken and the engine oil might leak.
Engine
Detach the original
element
Engine
Sensor attachment
(commercially available)
O ring
→ To sensor wire
Sensor
Wind Teflon tape.
Thread size 1/8PT
Be sure not to
twist.