Satin stitches – Brother PC 8500 User Manual
Page 95
92
(Programmed
SATIN STITCHES
1. Touch the “CHARACTER/DECORATIVE STITCH” key.
The different types of patterns available will be displayed.
2. Touch the “
” key.
The satin stitch selection screen will be displayed.
*
The thread may easily become knotted when certain types
of fabric or thread are used; therefore, the feed should be
adjusted according to the application.
1
Pattern selection keys
2
Touch this key to adjust the stitch width and stitch length
settings.
3
Touch this key to change the thread tension.
4
Touch this key to save a pattern combination to memory.
(Refer to page 100.)
5
Touch this key to select single or repeat sewing. (Refer to
page 89.)
6
Touch this key if you would like to change the pattern length
without changing the stitch width or stitch length settings.
(Refer to page 95.)
7
Touch this key to move the pattern up by about half of it’s
finished height when sewing. (Refer to page 97.)
8
Touch this key to move the pattern down by about half of it’s
finished height when sewing. (Refer to page 97.)
9
Touch this key to cancel your entry.
0
An advice screen will appear if you touch this key while
sewing. (Refer to page 42.)
A
Touch this key to confirm your entry. (Refer to 100.)
3. Touch the pattern that you would like to use. The pattern
you touch will then be selected for use.
*
If you select the wrong pattern by mistake, touch the
“CLEAR” key to clear the pattern selection.
*
Up to 70 different patterns can be combined into a single
pattern.
1
2
3
4
5
6
7 8
A
0
9