Bobbin winding/bobbin thread setting, Bobbin winding / bobbin thread setting, Winding the bobbin and setting the bobbin thread – Brother PC 8500 User Manual
Page 19
(Programmed
16
BOBBIN WINDING / BOBBIN THREAD SETTING
Winding the bobbin and setting the bobbin thread
3
7
9
2
5
1
6
4, 8
1
2
3
1
2
3
1. Connect the machine to the power supply and turn on the
main power.
2. Place the spool of thread on the spool pin. The thread end
should come from the bottom front of the spool. The spool
cap closest to the thread spool size should be used to hold
the spool securely on the spool pin.
1
Spool cap
2
Spool
3
Spool pin
*
The spool cap should be pushed on as far as it will go.
Note
If using a fine thread such as cross wound thread, slightly
separate the spool cap (small) from the spool of thread before
using it.
1
Cross wound thread
2
Spool cap (small)
3
Gap
3. Steady the spool thread in your right hand, take the end of
the thread in your left hand, and pass it through the guides
in the order shown by the numbers.