Changing the presser foot, Installing embroidery foot “q – Brother PC 8500 User Manual

Page 34

CHANGING THE PRESSER FOOT

Change the presser foot according to the LCD message

1. Push the “NEEDLE POSITION” button to raise the needle,

and then turn off the power.

2. Raise the presser foot lever.

Installing embroidery foot “Q”

1. Push the “NEEDLE POSITION” button to raise the needle,

and then turn off the power.

2. Raise the presser foot lever.

3. While pressing the black button to the left of the presser foot

holder, pull the presser foot holder downward to remove it.

3. Press the black button located at the back of the presser

foot holder to release the foot.

Presser foot holder

4. Place the presser foot pin directly below the holder-end and

lower the presser foot lever.

Holder-end

Foot pin

(Programmed

in Machine)