Brother BE-1201B-AC-PC - Manual (Page 34)

2-6 BE-0901E-AC-PC• BE-1201B-AC-PC
Chapter 2 Preparation of Embroidery Machine
2-6 Lubrication to Needle Bar Case
CAUTION
Turn off the power switch before starting any cleaning work, otherwise the machine may operate if the
start switch is pressed by mistake, which could result in injury.
Proper lubrication is necessary for keeping the machine head in good condition.
BE-0901E-AC-PC
W1570
BE-1201B-AC-PC
W1570
Before operating the machine for the first time
after unpacking or after leaving the machine
without operation for a long period of time,
supply one or two drops of oil to two sections at
the top and the bottom of each needle bar. (See
the left figure.)
Note)• Use the Brother's specified embroidery
machine oil (Nisseki Embroidery Lube No.
10 or the equivalent).
• Supplying an excessive amount of oil
will cause dripping onto the material.