Brother BE-1201B-AC-PC User Manual
Page 230
11-2
BE-0901E-AC-PC• BE-1201B-AC-PC
Chapter 11 Error code list
Code
Error
Measures
E-00
No error occurs.
E-01
E-01ERROR 01Either motor of main shaft, X-
or Y-axis has locked..
This is not usually displayed.
E-02
Overtravel occurs during home position
detecting movement.
Turn the power off and on once. If the same error occurs again,
the area sensor is faulty.
E-03
The stop switch is pressed during home
position detecting movement.
Press the
to restart the home position detecting
movement again.
E-04
Zero detecting movement out of range
Turn the power off and on once. If the same error occurs again,
the home position sensor is faulty.
E-05
Needle stop position error
Adjust the pulley stop position (100 degrees) above the needle
and press the
.
E-06
Needle bar case position error
This is not usually displayed.
E-07
Needle bar case lock
Press the
. If the same error occurs again, the color
change mechanism is faulty.
E-08
Stop switch or emergency switch was pressed
while the needle bar case is traveling.
This is not usually displayed.
E-09
X-axis home position detection error
Turn the power off and on once. If the same error occurs again,
the X-axis mechanism is faulty.
E-0A
Thread breaking error
After passing through the thread, press the
.
E-0B
Stop or emergency stop during sewing
E-0C
Insufficient bobbin thread
E-0D
The machine does not return to the home
position.
E-0F
Undefined error
This is not usually displayed.
E-14
Y-axis home position error
Turn the power off and on once. If the same error occurs again,
the Y-axis mechanism is faulty.
E-15
Stop error during SSP processing (when
pressing the stop key while the hoop is moving) Hoop movement restarts if you press
.
E-16
Needle with specified number is out of movable
area.
E-17
Speed Vol. No. is out of range.
E-1A
Destination coordinates error
This is not usually displayed.
E-1C
The machine stops during mask tracing.
Tracing is cancelled if the
key is pressed when the
machine is stopped during mask tracing. Press the
key
to continue tracing
E-1D
The machine stops while the needle is moving
between patterns during repeat sewing.
This is displayed when the stop switch is pressed while the
hoop is moving. Press the
to move the hoop again. (It is
necessary to press the
again to start sewing.)
E-1F
Presser foot down error while searching for
home position just after the power is turned on.
Press the
. If the same error occurs again, adjust the
presser foot switch.