Grid, Hoop, Hoop position fine adjustment – Brother BE-1201B-AC-PC User Manual
Page 131
BE-0901E-AC-PC• BE-1201B-AC-PC
6-11
Chapter 6 Embroidering
Grid
Displays 1
× 1 cm square grids on the background.
1. Select [Grid] from View menu and put the check mark.
Before selecting
After selecting
W1071Q
W1072Q
Hoop
Displays the outline of embroidery hoop. The type of embroidery hoop can be changed in [Load
Hoop] of Settings menu.
!
Embroidering is allowed within the green guide in the hoop.
1. Select [Hoop] from the View menu and put a check mark.
If the hoop is not displayed, carry out the step to read the hoop. For details, refer to [Load Hoop]
(
→ page 6-46).
Before selecting
After selecting
W1073Q
W1074Q
Hoop position fine adjustment
Adjusts the view position of embroidery hoop.
!
The position can be adjusted in the range of ±20 mm in both the X and Y directions.
1. Select [Hoop position] from the View menu.
The hoop view position is stored in the hoop data. If you reinstall the program, the hoop view position
is initialized because it is overwritten.