beautypg.com

The tcp/ip protocol setting(windows me/98/95) – Buffalo Technology Buffalo AirStation WLAR-L11-L User Manual

Page 11

background image

WLAR-L11-L Internet Connections Manual

9

Install the following into the setting PC for setting the AirStation.

• LAN Board Driver............................................ Refer to the following "Installation of LAN Board (to the

setting PC)."

• AirStation Manager ................................................... Refer to the "Installing the AirStation Manager" section (page

12).

• TCP/IP Protocol .........................................................."

The TCP/IP Protocol Settings (for setting PC)" section (page 9)

• Web Browser (Internet Explorer 4.0 or later,

or Netscape Navigator 3.0 or later)...................................Refer to the relevant Web browser manual. Microsoft Internet

Explorer is installed as standard on Windows Me/98.

Refer to the LAN board manual for the installation.

When using the WLI-ISA-OP or WLI-PCI-OP

Before installing the Wireless LAN Card (WLI-PCM-L11 etc.), install the WLI-ISA-OP or WLI-PCI-OP
(hereinafter called the Adapter) and the bus adapter driver. Refer to the attached Bus Adapter Manual
for the installation procedure.When using the WLI-PCI-OP Adapter, a WLI-PCI Driver Disk is required.

Set a tentative IP address for the AirStation setting.
Set the IP address according to the following procedure.

The TCP/IP Protocol Setting(Windows Me/98/95)

The TCP/IP protocol is set as follows.

Installation of the LAN Board (for setting PC)

The TCP/IP Protocol Settings (for setting PC)

1

Start your PC.

2

Click the Start button, and then select Settings, and Control Panel.

3

Double-click the Network icon.

4

In the Network dialog box, verify that the TCP/IP is displayed in “The following
network components are installed” field.

Only

1

LAN board installed

The dial-up adapter and the LAN
boards are installed.

TCP/IP (LAN board driver name) is normally
displayed in “The following network compo-
nents are installed:” field.

If TCP/IP is not displayed, refer to the "Adding the TCP/IP Protocol (Windows Me/

98/95)" section (page 11) and add the Internet protocol (TCP/IP).

Continue to next page

KPVGTPGVDQQM TVR ''''և''''̙ ߆̙

'ވ'