Buffalo Technology Power Over Ethernet Receiver WLE-POE-R7 - Manual

■ NOTE: The WLE-POE-R33/R7 Adapter must be used with a compatible Power
Supply Adapter when supplying power to the AirStation. Check the specifications
on Page 4 to verify compatibility.
Package Contents:
Power Over Ethernet Receiver
Connecting to your
Power-Over-Ethernet Receiver
(WLE-POE-R33 / WLE-POE-R7)
The WLE-POE-R33/R7 Adapter is an adapter
that supplies power to the AirStation via a Power
Supply Adapter (such as the WLE-POE-S). Using
this product enables the AirStation to be used in
locations that are not provided with a nearby power
supply. The WLE-POE-R33/R7 Adapter can be
installed on the AirStation Wall Mounting Kit
(WLE-WK / WLE-WK33), which are sold
separately.
PY00-29025-DM20
◗ POE Receiver Adapter 1 (WLE-POE-R33 -OR- WLE-POE-R7)
◗ Attachment Bracket 1
◗ LAN Patch Cable 1
◗ 5mm Screws 2 (For mounting product to bracket)
◗ 12mm Screws 2 (For mounting bracket Wall Mount Kit)
◗ 16mm Screws 2 (For mounting bracket to wall)
◗ Rubber Feet 4
◗ Setup Guide 1 (This guide)
◗ Warranty Certificate 1
Precautions:
◗ After properly connecting all the devices, turn ON the power to the Supply
Adapter.
◗ Always connect the Supply Adapter to the Receiver Adapter's POE port.
◗ The Receiver and Supply cannot be attached by CAT5 longer then 100M.
◗ Use POE CAT5 cables (all eight wires)
◗ The products will become warm during use; this does not indicate
malfunction.