Toshiba Magnia Z500 - Manual (Page 86)

HW Diagnostics
Items of HW Diagnostics 84
[01. Sequential address read]
This subtest is a sequential reading of all the blocks on the
HDD, starting at block 0.
[02. Connection]
This subtest reads the logical sector at the end of the HDD, and
then recognizes if the drive is connected or not.
NOTE: The [01. Sequential address read] tests all areas of
the hard disk drive. If the capacities of installed hard disk
drives are large enough, the test may take a few hours.
If you do not know where the hard disk drives are connected
(host ID, SCSI ID and channel number of the SCSI
controller), you can find them from [01. INQUIRY] of [09.
SCSI TEST]..
SCSI HDD TEST (HDD)
Status Error name Meaning
01 CHECK CONDITION OR BAD
COMAND Bad command error
03 DRIVE SELECTION FAILED ID selection error
04 TARGET DRIVE BUSY The target drive is busy
05 SCSI BUS TIME OUT Time out error of SCSI bus
09 DMA BOUNDARY ERROR DMA BOUNDARY occurred
0D COMMAND TERMINATED A command terminated
0E QUEUE FULL Command queue is full
80 NO SENSE The sense data is invalid
81 RECOVERED ERROR The execution of the command has correctly
finished because ofrecovery treatment
82 NOT READY The condition does not satisfy for the com-
mand execution
83 MEDIUM ERROR An error occurred because of the failure of a
medium
84 HARDWARE ERROR A hard error that is impossibleto recover
occurred duringcommand execution
85 ILLEGAL REQUEST CBD is illegal
86 UNIT ATTENTION The function of hard disk drive has been
changed