Toshiba Satellite P200 (PSPBL) - Manual (Page 74)

User’s Manual 4-16
Operating Basics
Disconnecting the LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.
Wireless LAN
The wireless LAN is compatible with other LAN systems that comply with
the IEEE802.11a, 11b, 11g and Draft 11n wireless LAN standards.
It supports the following:
■ Automatic Transmit Rate Select mechanism in the transmit range of 54,
48, 36, 24, 18, 9, 6 Mbps for 802.11a/b/g and 802.11b/g wireless LAN
module.
■ Advanced Encryption Standard (AES) data encryption, based on 256bit
encryption algorithm.
■ Frequency Channel Selection (2.4GHz or 5GHz).
■ Roaming over multiple channels.
■ Card Power Management.
■ Wired Equivalent Privacy (WEP) data encryption.
Network
It may not be possible to make a network connection to a specified network
name using the ad hoc network function. If this occurs, the new network*
will have to be configured for all computers connected to the same network
in order to re-enable network connections.
* Please be sure to use new network name.
11a, 11b, 11g and 11n wireless are based on IEEE 802.11a, 802.11b,
802.11g and 802.11n respectively. The IEEE 802.11n specification has not
been finalized and is currently in draft release. The TOSHIBA 11a/b/g/n
Wireless LAN Adapters are based on the Draft Release, Version 1.0, of the
IEEE 802.11n specification. An Adapter with 11a/b, 11a/b/g or 11a/b/g/n
can communicate on any of its supported formats; the actual connection
will be based on the access point to which it connects.
Connection compatibility with the wireless equipment in Draft 11n mode is
not guaranteed.
The Draft 11n function cannot be used with WEP/TKIP. Draft 11n mode can
be used only with WPA-PSK (AES) mode or no security mode.