Toshiba Satellite P200 (PSPBL) - Manual (Page 65)

User’s Manual 4-7
Operating Basics
1. Click Start All Programs Protector Suite QL User Enrollment.
2. Click Next.
3. At the User’s Password screen which is then displayed, you should
ensure that the same Windows username is displayed before entering
the appropriate password into the Enter you password field. Once this
has been done, click Next.
4. At the hints for Fingerprint Enrollment screen, confirm the message
displayed and ensure that there is a check mark in the Run Interactive
Tutorial box. Once this has been done, click Next.
5. At the Correct swipe Procedure screen, confirm the message that is
diplayed and then click Next.
6. At the Scanning Practice screen, you are able to practice swiping your
finger to ensure you use the correct method. Once you have finished
practicing, click Next.
7. At the User’s Fingers screen, select the finger you wish to enroll from
the illustration and then click Next. On this screen please be aware that
any previously enrolled FingerPrints would have green check marks,
while the FingerPrint you are about to enroll will have a red check mark.
If any of the previously enrolled FingerPrints is selected again, the latest
information will be enrolled and any previous information over-written.
8. At Advanced Security screen, select whether you wish to enable the
security function, and then click Next.
9. At Finalization screen, click Finish - this will complete the fingerprint
registration process.
Window Logon via Fingerprint Authentication
If required, you are also able to use fingerprint authentication in place of the
usual Windows logon process using your username and password. This
method is specially useful where there are many users using the same
computer as it removes the need for actual user selection when the system
is started.
■ In use, the fingerprint authentication system will use the same
username and password as defined within Windows operating system.
If no Windows password has been configured, you must do this before
starting the fingerprint registration process.
■ Up to twenty-one fingerprint patterns can be registered on this sensor.
You are also able to start the User Enrollment Wizard by using the
following method.
■ Click the Protector Suite QL icon in the Task Bar.
■ Swipe your finger across the fingerprint sensor.