Toshiba Satellite P200 (PSPBL) - Manual (Page 73)

User’s Manual 4-15
Operating Basics
Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.
LAN
The computer is equipped with networking hardware that supports Ethernet
LAN (10 Mbps, 10 BASE-T), Fast Ethernet LAN (100 Mbps, 100 BASE-TX).
Connecting the LAN cable
If you are using Ethernet LAN (10 Mbps, 10 BASE-T), you can connect
using either a CAT5 or a CAT3 cable.
If you are using 100 BASE-TX Fast Ethernet or 1000 BASE-T Gigabit
Ethernet, you must connect using a CAT5 cable.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices connected
to the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear
the latch click into place.
Connecting the LAN cable
3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.
Do not install or remove an optional memory module while the Wake-up on
LAN feature is enabled.
The Wake-up on LAN feature does not work on battery power. In
Hibernation/Power off mode you should always leave the computer
connected to the AC adapter if you are using this feature.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.