Installing/removing batteries, Installing/removing batteries -17 – Toshiba Satellite P200 (PSPBL) User Manual
Page 146
User’s Manual
9-17
Optional Devices
Installing/Removing batteries
Be sure to install the dry batteries provided with this product using the
Remote Controller.
The procedures for installing and removing the bateries vary depending on
the type of the Remote Controller. Check the type and then install or
remove the bateries as instructed.
Store the battery for the remote control beyond the reach of children.
If a child swallows a battery, this might result in chocking. If it happens,
contact a doctor immediately.
Observe the following precautions when using the battery of the Remote
Controller.
■
Do not use batteries other than those specified.
■
Ensure that you insert the batteries with their polarities correctly
aligned (+ or -).
■
Do not recharge, heat, disassemble or shot the battery, or put it into a
fire or flame.
■
Do not use a battery whose ‘recommended expiration date’ has been
reached, or is completely discharged.
■
Do not use different type of battery or old and new batteries at the
same time.
■
Do not carry the battery together with metal necklaces, hairpins or
other metal accessories.
■
When storing or disposing of used batteries, make sure to put some
insulation tape on their terminal (+ and -) to avoid short-circuits.
If these precausions are not followed, heating, fluid leakage or explosion
may occur. This may cause bums or personal injury. If battery fluid gets on
your skin or clothes, wash immediately with clean water. If battery fluid
gets in your eyes, rinse your eyes with clean water immediately and see a
doctor. Do not touch the battery fluid on instruments or devices with bare
hands. Wipe off with a cloth or paper towel.