Pioneer AVIC-F10BT - Manual (Page 45)

Selecting a location you
searched for recently
The places that you have searched for in the
past are automatically stored in
“History”.
p If no location is stored in Destination His-
tory, you cannot select [ History]. (If you
perform a route calculation, you can select
[
History].)
p “History” can store up to 100 locations. If
the entries reach the maximum, the new
entry overwrites the oldest one.
1 Display the
“Destination Menu” screen.
2 Touch [History].
The
“Destination History List” screen ap-
pears.
3 Touch the entry you want.
The searched location appears on the map
screen.
Searching for a location by
coordinates
Entering a latitude and longitude pinpoints
the location.
1 Display the
“Destination Menu” screen.
2 Touch [Coordinates].
The
“Coordinate Input” screen appears.
3 Touch [East] or [West], and then enter
the longitude.
To enter W 50°1
’2.5” for example, touch
[ West], [0], [5], [0], [0], [1], [0], [2], and [5].
4 Touch [North] or [South], and then
enter the latitude.
To enter N 5°1
’2.5” for example, touch [North],
[0], [5], [0], [1], [0], [2], and [5].
5 Touch [OK].
The searched location appears on the map
screen.
Searching for and selecting a location
Engb
45
Chapter
08
Searc
hing
for
and
selecting
a
location