Pioneer AVIC-F10BT - Manual (Page 134)

The difference between “Custom1” and
“Custom2”
! A separate Custom1 curve can be created
for each source. If you make adjustments
when a curve
Super Bass, Powerful,
Natural, Vocal, Flat, or Custom1 is se-
lected, the equaliser curve settings will be
memorised in
Custom1.
! A Custom2 curve can be created common
to all sources. If you make adjustments
when
Custom2 curve is selected, the Cus-
tom2 curve will be updated.
! The adjusted Custom1 curve is memorised
for each of the source selected, but one
curve is shared for the following sources.
— CD, ROM, DVD-V, DVD-VR, DivX
— AM and FM
— EXT1 and EXT2
— AV1 and AV2
— SD and USB
! The different source volume level can be
set between iPod and USB.
! When [Flat] is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equaliser
curves by switching alternatively between
[
Flat] and a set equaliser curve.
1 Touch [EQ] on the
“AV Sound Settings”
menu.
= For details, refer to Displaying the “AV
Sound Settings ” menu on page 132.
2 Touch the one of keys to select a curve
that you want to use as the basis of custo-
mising.
3 Touch [Customize].
4 Touch the frequency that you want to
adjust the level.
5 Touch [a] or [b] to adjust the level of
the equaliser band.
Each time you touch [a] or [b], the level of
the equalisation band increases or decreases.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Touch [Loudness] on the “AV Sound
Settings ” menu.
= For details, refer to Displaying the “AV
Sound Settings ” menu on page 132.
2 Touch [Loudness] to select the level you
want.
Each time you touch [
Loudness], the level is
selected in the following order:
Off
— Low — Mid — High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
p Only when “Sub Woofer” is [On], you can
adjust
“Phase”, “Level” and “Frequency”.
1 Touch [Sub Woofer] on the
“AV Sound
Settings
” menu.
= For details, refer to Displaying the “AV
Sound Settings
” menu on page 132.
2 Touch [On] to turn subwoofer output
on.
To turn subwoofer output off, touch [
Off].
3 Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
4 Touch [+] or [
–] next to “Level” to adjust
the output level.
+6 to
–24 is displayed as the level is increased
or decreased.
5 Touch [c] or [d] next to “Frequency” to
select cut-off frequency.
Each time you touch [c] or [d], cut-off fre-
quencies are selected in the following order:
50 Hz
— 63 Hz — 80 Hz — 100 Hz — 125 Hz
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
Customising preferences
Engb
134
Chapter
29