Pioneer AVIC-HD3-II - Manual (Page 80)

The power voltage (reference value) pro-
vided from the vehicle battery to the naviga-
tion system is shown. If the voltage goes
out of the range from 11 V to 15 V, check
that power cable connection is correct.
7 Illumination
When the headlights or small lamps of a ve-
hicle are on, [
On] is displayed. When the
small lamps of a vehicle are off, [ Off] is dis-
played. (If the orange/white lead is not con-
nected, [
Off] appears.)
8 Back Signal
When the gear lever is shifted to
“R”, the
signal switches to [ High] or [Low]. (One of
these is displayed depending on the vehi-
cle.)
Checking sensor learning
status and driving status
1 Touch [Settings] in the navigation
menu, then touch [Hardware].
2 Touch [3D Calibration Status].
The 3D Calibration Status screen appears.
1
2
3
4
5
6
7
1 Distance
Driving distance is indicated.
2 Speed Pulse
Total number of speed pulses is indicated.
3 Learning Status
Current driving mode is indicated.
4 Degree of learning
Sensor learning situations for distance
(
Distance), right turn (Right Turn), left turn
( Left Turn) and 3D detection (3D Detec-
tion) are indicated by the length of bars.
p When tyres have been changed or
chains fitted, turning on the Speed
Pulse allows the system to detect the
fact that the tyre diameter has changed,
and automatically replaces the value for
calculating distance.
p If ND-PG1 is connected, the distance
calculation value cannot be replaced
automatically.
5 Speed
The speed detected by the navigation sys-
tem is indicated. (This indication may be
different from the actual speed of your vehi-
cle, so please do not use this instead of the
speedometer.)
6 Acceleration or deceleration/Rotational
speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
7 Inclination
Degree of slope of the street that you are
currently running is indicated.
To clear values...
If you want to delete the learned results stored
in [
Distance], [Speed Pulse] or [Learning Sta-
tus], touch the relevant result, then touch
[
Yes].
p If you select [Learning Status], you can se-
lect [ Reset All] or [Reset Distance Study].
To clear all learning statuses, touch [ Reset
All]. To clear only the Distance study, touch
[
Reset Distance Study].
p Touch [Reset All] for the following cases:
— After changing the installation position
of the navigation system
— After changing the installation angle of
the navigation system
— After moving the navigation system to
another vehicle
p When the distance accuracy is low, touch
[ Reset Distance Study].
p Touching [Reset All] returns the installa-
tion angle setting also to the default or fac-
tory setting. Reconfigure the setting.
Modifying the General Settings for Navigation Functions
Engb
80
Chapter
10