Pioneer AVIC-HD3-II - Manual (Page 129)

1 Touch [FAD/BAL] in Audio Settings
menu.
The FAD/BAL screen appears. When
Rear SP
(the subwoofer controller setting in
System Settings menu) is Sub.W, Balance
will be displayed instead of
FAD/BAL.
= For details, refer to Setting the rear output
and subwoofer controller on page 136
2 Touch a or b to adjust front/rear
speaker balance.
Each time you touch a or b moves the front/
rear speaker balance towards the front or the
rear.
Front: 15 to Rear: 15 is displayed as the front/
rear speaker balance moves from front to rear.
When the rear output setting is
Rear SP
Sub.W, you cannot adjust front/rear speaker
balance.
= For details, refer to Setting the rear output
and subwoofer controller on page 136
3 Touch c or d to adjust left/right speak-
er balance.
Each time you touch c or d moves the left/
right speaker balance towards the left or the
right.
Left: 9 to Right: 9 is displayed as the left/right
speaker balance moves from left to right.
Using subwoofer output
This navigation system is equipped with a sub-
woofer output which can be turned on or off.
p When the subwoofer output is on, you can
adjust the cut-off frequency, the output
level, and the phase of the subwoofer.
1 Touch [Sub Woofer] in Audio Settings
menu.
When
Preout (the subwoofer controller set-
ting in System Settings menu) is Full, you
cannot select [ Sub Woofer].
= For details, refer to Setting the rear output
and subwoofer controller on page 136
2 Touch [On] to turn subwoofer output
on.
To turn subwoofer output off, touch [
Off].
3 Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
p If subwoofer output sound is not clear with
[ Normal], change it to [Reverse].
4 Touch c or d to select cut-off fre-
quency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50
— 80 — 125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
5 Touch [+] or [-] to adjust the output
level of the subwoofer.
+6 to -6 is displayed as the level is increased
or decreased.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through navigation
system
’s low pass filter (for the subwoofer),
but is output through the RCA output.
1 Touch [Non Fading] in Audio Settings
menu.
Only when
Preout (the subwoofer controller
setting in System Settings menu) is Full, you
can select [ Non Fading].
= For details, refer to Setting the rear output
and subwoofer controller on page 136
2 Touch [On] to turn non fading output
on.
To turn non fading output off, touch [
Off].
Customising the Audio Setting related with Audio Visual
Engb
129
Chapter
15
Customising
the
Audio
Setting
related
with
Audio
Vi
sual