Pioneer MCS-FS131 - Manual (Page 46)

Getting Started 46
En
Getting Star
ted
3
Operating the TV with
the player’s remote
control
:KHQWKHPDQXIDFWXUHUFRGHIRU\RXUEUDQG
of TV is set on the player’s remote control, the
TV can be operated using the player’s remote
control.
Caution
‡ For some models it may not be possible to operate
the TV with the player’s remote control, even for
TVs of brands listed on the manufacturer code list.
‡ The setting may be restored to the default after the
batteries are replaced. If this happens, reset it.
1. Input the 2-digit manufacturer code.
Press the number buttons (0 to 9) to input
the code while pressing TV CONTROL 1.
Note
y The factory default setting is 00 (PIONEER).
y If you make a mistake when inputting the code,
release TV CONTROL 1 then start over from the
beginning.
y :KHQWKHUHDUHPXOWLSOHFRGHVIRUD
manufacturer, try inputting them in the
indicated order until the TV can be operated.
2. Check that the TV can be operated.
Operate the TV using TV CONTROL.
1
– Press to turn the TV’s power on and off.
INPUT SELECT – Press to switch the TV’s
input.
CH +/–
– Press to select the TV channel.
VOL +/– – Press to adjust the volume.