Pioneer AVIC-HD3-II - Manual (Page 161)

Registration is not available.
If you try to perform another opera-
tion immediately after connection
failure. Wait for a while and retry.
Reading failed. If you transferred the data from your
mobile phone in a format can not
be received with navigation system. ! Select just a suitable item, format, and then
retry.
! Connect your mobile phone again and
retry.
Calibration failed. Please refer
to the owner
’s manual.
The touch panel calibration has not
been carried out with appropriate
steps. Please read the instruction of touch panel ca-
libration and retry. (Page 167)
The HDD is not connected. Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error. Consult your dealer.
Cannot use HDD. Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error. Consult your dealer.
There is no applicable pro-
gram. Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error. Consult your dealer.
The HDD cannot be operated
due to excessive heat. Please
move your vehicle to a safe
place and turn the power off
until the temperature goes
down. Hard disk drive cannot run due to
high temperature. Park your vehicle to safe place, turn the igni-
tion switch off, and wait until the temperature
inside the vehicle drops.
Messages for Audio Functions
When problems occur in the audio source, a message may appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest Pioneer Service Centre.
Built-in DVD drive
Message When What to do (See)
Unreadable disc If you try to use a disc which is in-
compatible with this system. Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise
damaged. Insert a normal, round disc.
Mechanical failure of DVD drive oc-
curs. Consult your Pioneer dealer.
Playback error. Please remove
the disc. Electrical or mechanical error has
occurred. Press RESET button. (Also see the Hardware
Manual.) (Page 164)
Region code error The disc does not have the same re-
gion number as the navigation sys-
tem. Replace the DVD-Video with one bearing the
correct region number.
Appendix
Engb
161
Appendix
Appendix