Pioneer AVIC-HD3-II - Manual (Page 159)

Route calculation not possible
because destination is too far.
The destination is too far. ! Set a destination closer to the starting
point.
! Set one or more waypoints.
Route calculation not possible
because destination is too
close. The destination or waypoint(s) are
too close. Set a destination and waypoint(s) farther
from the starting point.
Route calculation not possible
due to traffic regulations.
• The destination or waypoint(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the route
calculation is hampered.
! Set a destination and waypoint(s) outside
the CTR if you know where the restricted area
is.
! Try a destination or waypoint(s) away from
the currently set points to some extent.
! Drive your vehicle to an unrestricted area
and reset the destination and waypoint(s).
Route calculation not possible
because navigation cannot be
provided around destination
or starting point. The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible. ! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Route to destination cannot
be calculated. The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear. Change the destination.
• Ferry could not be avoided.
• Toll roads could not be
avoided.
• Motorway could not be
avoided.
• Ferry, toll roads and motor-
ways could not be avoided.
• Ferry and toll roads could
not be avoided.
• Toll roads and motorways
could not be avoided.
• Ferry and motorways could
not be avoided.
These messages appear when a
ferry route, toll roads, or motorways
are included in the route to the des-
tination or waypoints even though a
route is set to avoid them.
You can identify these condition by
the icons. If the current route is not desired, set destina-
tion or waypoints that do not pass through a
ferry route, toll roads, or motorways. (Page
27)
This area does not contain
any POI's of the selected type. Facilities of the selected category do
not exist in the surrounding areas. Use another search method or move to an-
other location and perform
Vicinity Search
again.
Failed to make the route pro-
file. In rare cases, a route calculation
error may occur. ! Retry.
! Consult the Pioneer Local dealer if this mes-
sage persists.
There is no pictures folder.
Please create /Pictures/ folder
and store JPEG files in that
Folder. Cannot load the image because Pic-
tures folder is not found in the in-
serted disc.
Use the appropriate data after reading “Page
78 ”.
Data Read error. Failed to read the data because the
CD-R is damaged or dirty. Or, the
pick-up lens of the DVD drive is
dirty. Try re-reading the data by inserting a clean
CD-R. Clean the pick-up lens with a commer-
cially available cleaning kit for DVD, then try
to reading again.
Pictures folder exists on the CD-R
but no data in JPEG format exists. Use the appropriate data after reading
“Page
78
”.
Appendix
Engb
159
Appendix
Appendix