Konica Minolta BIZHUB C351 - Manual (Page 61)

Setting Up Network Printing 3
C351 3-6
5
Specify settings for the following:
IP Address: Set the IP address of this machine.
Subnet Mask: Set the subnet mask for the network to which you are
connecting.
Default Gateway: Set the default gateway address for the network to
which you are connecting.
6
Touch [OK].
7
To apply the settings, restart this machine (turn it off, then on again).
– When turning the power off, then on again, be sure to turn the sub-
power switch off first, then the main power switch. In addition, wait
at least 10 seconds before turning the power on again; otherwise,
this machine may not function properly.
Turn this machine back on to apply the IP address.
!
Detail
Although a fixed IP address is entered without using the DHCP server in
the procedure described here, it is also possible to automatically assign
the IP address from the DHCP server. When “IP Address Setting Method”
is specified as “Auto Input” and “DHCP Setting” is set to “ON” on the set-
ting screen that is displayed, the IP address, subnet mask, and gateway
address settings are automatically assigned from the DHCP server on the
network, so it is not necessary to assign them manually. However, note
the following when setting “DHCP Setting” to “ON”.
Check with the network administrator that the DHCP server exists. If the
DHCP server does not exist, be sure to specify settings for “IP Address”,
“Subnet Mask”, and “Default Gateway”.
If the settings for the IP address and other items have been assigned us-
ing the DHCP server, there is a possibility that they may be automatically
changed. When the settings for the IP address and other items are
changed, if the IP address has been used to specify a printer on the net-
work for printing, there is a possibility that printing may not be possible
because this machine cannot communicate with the network. If “DHCP
Setting” has been set to “ON”, it is recommended that the IP address as-
signed to this machine be fixed in the DHCP server settings.