Konica Minolta BIZHUB 223 - Manual (Page 141)

bizhub 423/363/283/223 7-9
7.1 [System Settings] 7
[Finisher Adjustment] Adjust the staple, folding, and punch position of the Finisher FS-527. Oth-
erwise, adjust where to place the paper alignment plate of the Finisher FS-
529.
This item is displayed if the Finisher FS-527 or Finisher FS-529 is in-
stalled.
d
Reference
Create a sample in advance, and then adjust them while
checking the sample.
[Center Staple Position] p. 7-12
[Half-Fold Position] p. 7-13
[Punch Horizontal Position Ad-
justment] p. 7-13
[Punch Regist Loop Size Adjust-
ment] p. 7-14
[Paper Alignment Plate Settings] p. 7-14
[Paper Separation Adjust-
ment] Adjust the paper position where the two sides are separated for 2-sided
print.
[Gradation Adjustment] Adjust irregular gradation levels of print images.
[Maximum Density Adjustment] This function is useful when the re-
quired printing result is not obtained,
for example, the printing density is too
high or too low. Scan the amount of
toner adhered on an output test pat-
tern, and adjust to the optimal density.
For details, refer to page 7-14.
[Gradation Adjustment] This function is useful when a print im-
age is not reproduced with consistent
density. Scan the density of an output
test pattern and adjust to the optimal
gradation. For details, refer to
page 7-15.
[Initialization] Clear the correction values of both
[Maximum Density Adjustment] and
[Gradation Adjustment], and return
them to the factory default value (0).
For details, refer to page 7-16.
[Scanner Area] Adjust the scan range of the scanner.
For details on displaying this item, contact your service representative.
[ADF Adjustment] Make adjustments for scanning images in the ADF.
For details on displaying this item, contact your service representative.
[Line Detection] [Prior Detection Setting] Configure whether to issue an alert
when the Slit Scan Glass is dirty.
•
Select an alert display format and
contamination detection level.
[Feed Cleaning Settings] Configure whether to remove a dirt on
the Slit Scan Glass each time one
sheet of paper passes through the
ADF when scanning an original using
the ADF.
[User Paper Settings] Configure special paper settings for [User Paper 1] through [User Paper 4].
Settings to configure include Basic Weight and Media Adjustment.
For details on displaying this item, contact your service representative.
Settings