Konica Minolta Konica Minolta 240f - Manual (Page 56)

Loading documents 2
2-32 Konica Minolta 240f
2.8
2.8.3 Scanning area
The scanned area is shown below.
2.8.4 Loading documents in the Auto Document Feeder (ADF)
1
Place the document face up, and lightly insert the document until the document edge stops on the ADF.
2
Adjust the document guides to the document width.
d
Be sure any correction fluid, ink, or stamps on the document are completely dry before loading.
Remove all metals (staples, paper clips, etc.) before loading the documents. Failure to do so may cause a
malfunction.
Do not load the document with the document guide extended. The document may be reduced and printed.
Doing so may result in skewed feeding.
Do not add or remove the documents while they are being scanned. A document jam may occur.
Do not leave too many scanned documents on the document outlet. A document jam around the outlet may
occur.
When scanning is complete, remove the documents from the document exit tray to avoid document jams.
Scanned area
A4 Letter
Fax: 3 mm
Copy, Scan: 0 mm
Fax: 3 mm
Copy, Scan: 2 mm
Fax: A4 208 mm/Letter 214 mmm
Copy, Scan: A4 210 mm/Letter 216 mmm