Konica Minolta bizhub PRESS C1085 - Manual (Page 42)

Loading Paper 5
5-4 bizhub PRESS C1100/C1085
5.1
7
Load the remaining paper into the tray, then press the rear
guide plate against the paper.
NOTICE
Be careful not to load paper above the , mark that indicates
the height limit on the side guide plate. Otherwise, a paper
jam may occur.
To load paper with a width less than 139.7 mm/5.5", use the
small size guides built in to the side guide plates. For in-
formation about how to use the small size guides, refer to
the [HTML User's Guide].
Be sure that the rear guide plate is securely pressed
against the paper. If there is any gap between the rear
guide plate and the paper, this machine will not be able to
detect the correct paper size. It may cause a paper feeder
machine trouble.
Load paper with the print side facing up.
8
Close the tray.
% Push the tray in until it locks into place.
The amount indicator changes from to in the tray information display area of the [MA-
CHINE] or [COPY] screen.
NOTICE
Carefully close the tray. Otherwise, the machine may be subjected to an unexpected impact due to the
tray or paper weight, which may lead to a machine error.
5.1.2 Loading Paper in Post Inserter of Folding Unit FD-503
Select [Paper Setting] on the [MACHINE] screen or the [COPY] screen, then change the paper setting of the
upper tray or lower tray of the post inserter.
1
Load paper into the upper tray or lower tray of the post in-
serter.
The Amount indicator changes from to on
the [MACHINE] screen or the [COPY] screen.
2
Press the tray guide plates against the paper.
NOTICE
Do not load more than 500 sheets (80 g/m 2 / 21 lb Bond) for each of the upper and lower trays. Also, do
not load above the limit line indicated on the tray guide plates.