Konica Minolta bizhub PRESS C1085 - Manual (Page 106)

Convenient Use of Scan Function (Scan to SMB) 8
8-12 bizhub PRESS C1100/C1085
8.3
Step 2: Connect this machine to the network
To connect this machine to the network, check that:
- The LAN cable is connected.
- The IP address is assigned to this machine.
Tips
- To configure the network settings, select Web Tools - [Configure] - [Launch Configure] - [Network]. For
details, refer to the [HTML User's Guide].
Step 3: Prepare the operating environment for SMB transmission
Enable the SMB transmission function.
- Set [SMB Send Setting] of this machine to [Enable] (in general use, you do not need to change the de-
fault setting).
Tips
- For details, refer to the [HTML User's Guide].
Step 4: Configure settings according to your environment
Register destinations that are frequently used.
- This can save many steps to manually enter destinations.
- Select [Scan] tab of this machine to register the SMB server setting.
- You can also use [Scan Address Register] in [Utility] to register the setting.
Tips
- For details about how to register destinations, refer to the [HTML User's Guide].
Step 5: Send scan data to a public folder
Send scan data to a public folder of the registered SMB server.
- In the [Scan] tab of this machine, select an SMB destination, configure [Scan Settings], then press
Start.
Tips
- For details about scan operations, refer to the [HTML User's Guide].