Kramer Electronics SV-307 - Manual (Page 24)

Grounding the Wall Plate
21
Figure 4: Terminal Block Pinouts (U.K. and Europe)
SV-301, SV-304, SV-305 SV-301xl, SV-302, SV-303, SV-306
Notes:
•
The PC and Video terminal blocks have 9 contacts and the DDC terminal
block has 8 contacts
• Use the connector clips when removing the wires, not when inserting them
• Each wire protrudes 9mm in length from the plastic insulation so that it can
be easily connected. To prevent the wires crossing, be sure that each wire is
completely inserted
• The cable Ground shielding must be connected / soldered to the connector
shield
7 Grounding the Wall Plate
The grounding screw is used to earth the chassis of the unit to the ground of the
building, thus preventing static electricity from interfering with the product’s
performance.
Table 16 defines the grounding screw components.
Table 16: Grounding Screw, Lock Washers and Ring Tongue Terminal
# Item
1 M3X6 screw
2 1/8" Toothed Lock Washer
3 M3 Ring Tongue Terminal