Kramer Electronics VS-169TP - Manual (Page 40)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Kramer Protocol 2000
36
Table 9: Instruction Codes for Protocol 2000
Note: All values in the table are decimal, unless otherwise stated.
INSTRUCTION DEFINITION FOR SPECIFIC INSTRUCTION NOTE
# DESCRIPTION INPUT OUTPUT
0 RESET VIDEO 0 0 1
1 SWITCH VIDEO Set equal to video input
which is to be switched
(0 = disconnect)
Set equal to video output which is
to be switched
(0 = to all the outputs)
2, 15
2 SWITCH AUDIO Set equal to audio input
which is to be switched
(0 = disconnect)
Set equal to audio output which
is to be switched
(0 = to all the outputs)
2
3 STORE VIDEO STATUS Set as SETUP # 0 - to store
1 - to delete
2, 3, 15
4 RECALL VIDEO STATUS Set as SETUP # 0 2, 3, 15
5 REQUEST STATUS OF A
VIDEO OUTPUT
Set as SETUP # Equal to output number whose
status is reqd
4, 3
6 REQUEST STATUS OF AN
AUDIO OUTPUT
Set as SETUP # Equal to output number whose
status is reqd
4, 3
8 BREAKAWAY SETTING 0 0 - audio-follow-video
1 - audio breakaway
2
1 0 - FOLLOW mode
1 - Normal mode
15
11 REQUEST BREAKAWAY
SETTING
Set as SETUP #, or
set to 126 or 127 to
request if machine has this
function
0 - Request audio breakaway
setting
1 - Request “FOLLOW” setting
3, 4, 6, 15
15 REQUEST WHETHER SETUP
IS DEFINED / VALID INPUT IS
DETECTED
SETUP #
or
Input #
0 - for checking if setup is defined
1 - for checking if input is valid
8
16 ERROR / BUSY For invalid / valid input (i.e.
OUTPUT byte = 4 or
OUTPUT byte = 5),
this byte is set as the input
#
0 - error
1 - invalid instruction
2 - out of range
3 - machine busy
4 - invalid input
5 - valid input
6 - RX buffer overflow
9, 25
18 RESET AUDIO 0 0 1
19 STORE AUDIO STATUS Set as SETUP # 0 - to store
1 - to delete
2, 3
20 RECALL AUDIO STATUS Set as SETUP # 0 2, 3
30 LOCK FRONT PANEL 0 - Panel unlocked
1 - Panel locked
0 2
31 REQUEST WHETHER PANEL
IS LOCKED
0 0 16
44 SWITCH CONTROL DATA Set equal to control data
input which is to be
switched
(0 = disconnect)
Set equal to control data output
which is to be switched
(0 = to all the outputs)
2,27
45 REQUEST STATUS OF
CONTROL DATA OUTPUT
Set as SETUP # Equal to output number whose
status is reqd
3,4,27
58 EXECUTE LOADED DATA Set as 0, or as SETUP #. 1-Take
2-Cancel
22, 3
59 LOAD VIDEO DATA Set equal to video input
(0 = disconnect)
Set equal to video output
(0 = to all the outputs)
22, 23
(127 = load SETUP #) or SETUP #
60 LOAD AUDIO DATA Set equal to audio input
(0 = disconnect)
Set equal to audio output
(0 = to all the outputs)
22, 23
(127 = load SETUP #) or SETUP #