3 controlling via the ethernet, Controlling via the ethernet, Figure 8: local area connection properties window – Kramer Electronics VS-169TP User Manual
Page 23
Control the VS-169TP 16x9 CAT 5 Matrix Switcher
19
19
7.3 Controlling via the ETHERNET
You can connect the VS-169TP via the Ethernet, using a crossover cable
(see
Section 7.3.1
) for direct connection to the PC or a straight through cable
(see
) for connection via a network hub or network router
7.3.1 Connecting the ETHERNET Port directly to a PC (Crossover Cable)
You can connect the Ethernet port of the VS-169TP to the Ethernet port on
your PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the
VS-169TP during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
).
Figure 8: Local Area Connection Properties Window
1 After connecting the Ethernet port, you have to install and configure your Ethernet Port. For detailed instructions, see the
“Ethernet Configuration (FC-11) guide.pdf” file in the technical support section on our Web site: