Kramer Electronics VS-169TP - Manual (Page 30)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-169TP 16x9 CAT 5 Matrix Switcher
26
3. Press the TAKE button to confirm the action.
All the outputs are cleared.
9.4 Confirming Settings
You can choose to work in the At Once or the Confirm mode.
In the At Once mode (TAKE button does not illuminate):
• Pressing an OUT-IN combination implements the switch immediately
• You save time as execution is immediate and actions require no user
confirmation
• No protection is offered to allow the correction of an erroneous action
before it is implemented
In the Confirm mode (TAKE button illuminates):
• You can key-in and then confirm it by pressing the TAKE button, to
simultaneously activate the multiple switches
• Every action requires user confirmation, protecting against erroneous
switching
• Execution is delayed 1
9.4.1 Toggling between the At Once and Confirm Modes
until the user confirms the action
To toggle between the At Once and Confirm modes, do the following:
1. Press the TAKE button to toggle from the At Once mode (in which the
TAKE button does not illuminate) to the Confirm mode (in which the
TAKE button illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the Confirm mode
back to the At Once mode.
Actions no longer require user confirmation and the TAKE button no
longer illuminates.
These actions cannot take place when the TAKE button blinks
9.4.2 Confirming a Switching Action
To confirm a switching action (in the Confirm mode), do the following:
1. Press an OUT-IN combination.
The corresponding 7-segment display blinks and the MATRIX
SELECTOR display alternates between “CURRENT” and “UPDATED”.
The TAKE button also blinks.
1 Failure to press the TAKE button within one minute (the Timeout) will abort the action