Kramer Electronics VS-162AVM - Manual (Page 51)

Flash Memory Upgrade
47
47
5. Press and hold the TAKE button while simultaneously turning on the
POWER switch on the unit.
After a few seconds, following the initial machine identification message,
the MATRIX display shows the following message:
Please,
release key TAKE
6. Release the TAKE button.
The TAKE LED flashes and the MATRIX display shows the following
message:
Update program?
Please confirm < TAKE >
7. Press the TAKE button.
The MATRIX display shows the following message:
YOU will lose current SETUP 1
8. Press the TAKE button again.
The MATRIX display shows the following message:
Confirm < TAKE >
Are you ABSOLUTELY sure?
Press TAKE to execute
At this stage, and at any time previously, you can cancel the operation by
pressing any button, other than the TAKE button.
9. Press the TAKE button once again.
The program starts working and the TAKE LED turns off.
The MATRIX display shows the following message:
ERASE flash MEMORY
Please, wait…
10. After a few seconds the FLASH memory is erased and the MATRIX
display shows the following message:
Ready for receiving
Start transmission from PC
Note: If upgrading the firmware on more than one unit, be sure to
perform the above steps, 5 to 9, on each unit before continuing.
11. From your PC’s K-Sender program, click the Send button.
The color of the Send button changes to red and numbers appear
1 Upgrading firmware resets your unit to the factory default. This includes erasing all setups