Kramer Electronics VS-162AVM - Manual (Page 47)

MENU Commands
43
43
11.8 Setting the IR REMOTE Control
Set the IR REMOTE control to enable remote control of the 16x16 Audio-
Video Router with Preview Monitor, using the Kramer Infrared Remote
Control Device 1 . Refer to the Infrared Remote Control Device user manual 2
To set the MACHINE#, press keys # + 1. This sets MACHINE#1.
,
for full details.
To enable IR REMOTE control (when set OFF), do the following:
1. Press the MENU button until reaching the IR REMOTE setting.
The MATRIX display shows the message:
IR REMOTE setting
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The displays show the messages:
Outkey 1: InfraredREMOTE OFF
2: InfraredREMOTE ON
current:
remote OFF
3. Press the OUT button 2.
The TAKE LED flashes and the displays show the messages:
Turn ON infrared REMOTE ?
Press TAKE to execute
Current:
remote OFF
4. Press the TAKE button again.
The displays show the messages:
Infrared REMOTE mode
changed
Current:
remote ON
11.9 Choosing the AUTO STORE Current SETUP
Choose whether or not to save the current setup automatically, that is,
whether to save the machine’s status on power down, so that it returns to the
same status after cycling power.
To save the current setup automatically (when set OFF), do the following:
1 After enabling the IR REMOTE control command, remotely control the unit via the RC-IR3 remote control transmitter
pointed at the remote receiver on the machine’s front panel (item 1 in
Figure 1 )
2 You can download the RC-IR3 user manual at http://www.kramerelectronics.com