Kramer Electronics VS-162AVM - Manual (Page 37)

Operating Your VS-162AVM
33
33
10.8.2 Recalling Setups
To recall a setting, do the following:
1. Press the RCL button.
The displays show the messages:
Enter SETUP number
use two digit # 01-60
RECALL
# xy
Where xy are the OUT buttons.
2. Press the appropriate two OUT buttons, using the OUTkeys # 1 to 9, and 10
(for 0). The OUTkeys function on a decimal-basis, and not on a positional-
basis. For example, to enter the # 14, press # 1 followed by # 4 (not # 14).
To enter the # 3, press # 3 followed by the TAKE button 1 .
The memory recalls the setup. The MATRIX display shows the flashing
setup, and the TAKE LED as well as the appropriate mode button 2 flashes.
The STATUS display shows the message:
RECALL
# xy
Where xy are the OUT buttons.
3. Preview the setup to decide if to implement it, by pressing the:
• VIDEO or the AUDIO button, for video or audio setups in the
BREAKAWAY mode. Pressing the AFV button has no effect if
setups are stored in the BREAKAWAY mode
• AFV button, for setups in the AUDIO-FOLLOW-VIDEO mode.
Pressing the VIDEO or the AUDIO button has no effect if setups
are stored in the AUDIO-FOLLOW-VIDEO mode
If you decide not to implement the setup, you can scan the other setups, by
pressing different OUT buttons. To stop previewing the setups, press a non-
relevant button, for example, an IN button.
4. Press the TAKE button.
The specific setup is implemented.
If trying to recall an empty setup 3
1 Alternatively, pressing # 10 followed by # 3 also enters the # 3
, the MATRIX display would show a
message saying that that particular setup is empty and would return you to
step 1 above.
2 VIDEO, AUDIO or AFV
3 That is, a setup # for which no setup is actually stored