Kramer Electronics VS-162AVM - Manual (Page 30)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your VS-162AVM
26
• Execution is delayed 1
• Protection is offered to prevent erroneous switching
until the user confirms the action
• You can key-in several actions and then confirm them by pressing
the TAKE button once, to simultaneously switch several outputs
To toggle between the AT ONCE (default) mode and the CONFIRM mode,
press the TAKE button.
In CONFIRM mode: actions require user confirmation and the TAKE LED
lights.
In AT ONCE mode: Actions do not require user confirmation and the
TAKE LED does not light.
When the TAKE LED flashes:
• You cannot toggle between the AT ONCE and CONFIRM modes
• You can execute the previous action, by pressing the TAKE
button
• You can cancel the previous action, by pressing a non-relevant
button (for example, the MENU button)
10.6 Switching
You can switch:
• One input to one output (see section 10.6.1 )
• Several inputs to several outputs (see section 10.6.2 )
• One input to all outputs (see section 10.6.3 )
10.6.1 Switching one Input to one Output
Pressing an OUT-IN combination when your unit operates in the AT ONCE
mode implements the switch immediately.
To switch one input to one output (AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX display shows the 2 flashing digits, representing the present
input number connected to that specific output 2
out # x
. If the present output is
clear, the 2 flashing digits 00 appear in the MATRIX display.
The STATUS display shows the message:
1 Failure to press the TAKE button within about 30 seconds (the Timeout) aborts the action
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9