Kramer Electronics VS-162AVM - Manual (Page 33)

Operating Your VS-162AVM
29
29
1. Repeat steps 1 and 2 above.
The TAKE LED flashes.
2. Press the TAKE button to confirm the action.
The selected input switches to all the outputs and the TAKE LED lights.
The MATRIX display shows the identical 2 non-flashing digits
(representing that input number) for all outputs.
10.7 Clearing
1
You can clear (delete):
• One output (see section 10.7.1 )
• Several outputs (see section 10.7.2 )
• All outputs (see section 10.7.3 )
10.7.1 Clearing an Output
To clear an output (in the AT ONCE mode):
1. Press the appropriate OUT button.
The MATRIX display shows the 2 flashing digits, representing the present
input number for that specific output 2
out # x
. If the present input is clear, the 2
flashing digits 00 appear in the MATRIX display.
The STATUS display shows the message:
Where x is the output number
2. Press the OFF button 3
out # x
reset
.
The input is cleared and the MATRIX display does not show any Input # in
its place.
The STATUS display momentarily shows the message:
Where x is the output number
To clear an output (in the CONFIRM mode (the TAKE LED is lit)):
1. Repeat step 1 above.
2. Press the OFF button
3 .
The MATRIX display shows the 2 flashing digits 00 instead of the previous
1 “Clearing” means disconnecting the output from any of the inputs, and leaving it disconnected
2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9
3 You can press the OFF button first, and then an OUT button (the order is irrelevant)