Kramer Electronics VS-162AVM - Manual (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your Audio-Video Router
8
# Feature Function
28 RS-485 Detachable Terminal
Block Port
PINS # 1 and # 2 are for vertical sync and Ground connection, and
PINS # 3 and # 4 are for RS 485
29 RS-232 IN 9-pin D-sub (F) Port Connect to the PC or the Remote Controller 1
30 RS-232 OUT 9-pin D-sub (M) Port Connect to the RS-232 IN 9-pin D-sub (F) port of the next unit in
the daisy-chain connection
31 SETUP DIP-switches DIP-switches for setup of the unit
32 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the machine via
an IR remote controller (instead of using the front panel IR receiver) 2
33 Power Connector with Fuse AC connector enabling power supply to the unit
34 Power Switch Illuminated switch supplying power to the unit
4.1 Using the IR Transmitter
You can use the RC-IR3 IR transmitter to control the machine via the built-
in IR receiver on the front panel or, instead, via an optional external IR
receiver 3 . The external IR receiver can be located 15 meters away from the
machine. This distance can be extended to up to 60 meters when used with
three extension cables 4
Before using the external IR receiver, be sure to arrange for your Kramer
dealer to insert the internal IR connection cable
13F
5 with the 3.5mm connector
that fits into the REMOTE IR opening on the rear panel. Connect the
external IR receiver to the REMOTE IR 3.5mm connector.
1 If the unit is not the first unit in the line, connects to the RS-232 OUT 9-pin D-sub (F) port of the previous unit in the line
2 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the VS-162AVM (only if the
internal IR connection cable has been installed) (See section
4.1 )
3 Model: C-A35M/IRR-50
4 Model: C-A35M/A35F-50
5 P/N: 505-70434010-S