Kramer Electronics VP-885 - Manual (Page 27)

Operating the VP-885
23 23
To set the audio gain levels, see Section 7.7 .
7.5 Choosing the Audio-Follow-Video or Breakaway Option
You can configure stereo audio signal switching in one of two ways:
• Audio-follow-video (AFV), in which all operations relate to both the
video and the audio channels (see Section 7.5.1
• Breakaway, in which video and audio channels switch independently (see
)
Section 7.5.2
7.5.1 Setting the Audio-Follow-Video Option
)
To set the Audio-follow-video (AFV) option, press the AFV button. One
of the following occurs:
• If the AUDIO and VIDEO configurations are the same, then the AFV
button lights. The audio follows the video
• If the AUDIO differs from the VIDEO, then the TAKE and the AUDIO
buttons flash. Also, the audio outputs of the STATUS 7-segment display
which change, flash 1
7.5.2 Setting the Breakaway Option
. Press the TAKE button to confirm the
modification. The audio follows the video
To set the Breakaway option:
• Press either the AUDIO (for audio control only) or the VIDEO (for video
control only) button. One of the following occurs:

If the AUDIO button lights, switching operations relate to Audio
 If the VIDEO button lights, switching operations relate to Video
The STATUS window displays audio or video settings according to your
selection.
7.6 Storing/Recalling Input-Output Configurations
You can store and recall up to 16 input-output configurations (or setups) in
non-volatile memory, using the OUTPUT (1-8) and OUTPUT (9-16)
SELECTOR buttons (see Figure 18 ).
1 This warns that you are about to modify the audio configuration for AFV operation