Kramer Electronics VP-885 - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-885
10
6 Connecting the VP-885
This section describes how to:
•
Connect audio inputs/outputs (see Section 6.1
• Connect to the VP-885 via RS-232 (see
)
Section 6.2
• Connect to the VP-885 via RS-485 (see
)
Section 6.3
• Connect to the VP-885 via the Ethernet port and configure the Ethernet
port (see
)
Section 6.4
• Set the DIP-switches (see
)
Section 6.5
To connect
)
1 the VP-885 to external devices as illustrated in the example 2
in Figure 3 :
Figure 3: Connecting the VP-885
1 You do not need to connect all inputs and outputs
2 Switch OFF the power on each device before connecting it to your VP-885. After connecting your VP-885, switch on its
power and then switch on the power on each device. DO NOT push in the rear panel Flash Program “PROG” button , it is
only used for upgrading to the latest Kramer firmware