Kramer Electronics VP-885 - Manual (Page 15)

Connecting the VP-885
11 11
1. Connect up to 8 video sources 1 to the BNC INPUT connectors 2
2. Connect up to 8 balanced stereo audio sources to the AUDIO INPUT
terminal blocks (see
.
Section 6.1
3. Connect up to 8 video acceptors to the BNC OUT connectors
).
2 .
4. Connect up to 8 balanced/unbalanced stereo audio acceptors to the
OUTPUT terminal blocks.
5. If required, connect a PC and/or controller to the:
 RS-232 port (see Section 8.1
 RS-485 port (see
)
Section 8.2
 Ethernet port (see
)
Section 8.3
6. Connect the power cord
)
3 (not shown in Figure 3 ).
6.1 Connecting a Balanced/Unbalanced Stereo Audio Input/Output
This section describes how to wire:
• A balanced stereo audio input/output connection (see Figure 4 )
• An unbalanced stereo audio input (see Figure 5 )
• An unbalanced source to a balanced input (see Figure 6 )
Figure 4 illustrates how to wire a balanced input/output connection.
Figure 4: Wiring a Balanced Stereo Audio Input/Output
Figure 5 illustrates how to wire an unbalanced acceptor to the balanced output
of the unit.
1 All signal connections using more than one cable to interconnect between the devices should be of equal length
2 5 BNC connectors per source/acceptor
3 We recommend that you use only the power cord that is supplied with this machine