Kramer Electronics VP-885 - Manual (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Defining the VP-885
8
Table 3: VP-885 Rear Panel Features
# FEATURE FUNCTION
1 INPUTS BNC Connectors Connect to the composite video (Video/Y) and digital audio (S/PDIF/C)
sources, or to the s-Video (Video/Y and S/PDIF/C) sources, or to the
component video (Y, CB/PB, CR/PR) sources
2 OUTPUTS BNC
Connectors
Connect to the composite video (Video/Y) and digital audio (S/PDIF/C)
acceptors, or to the s-Video (Video/Y and S/PDIF/C) acceptors, or to the
component video (Y, CB/PB, CR/PR) acceptors
3 REMOTE IR 3.5mm Mini
Jack
Connect to an external IR receiver unit for controlling the machine via an IR
remote controller (instead of using the front panel IR receiver) 1
4 EXT. SYNC BNC
Connector
Connects to the external sync source
5 RS-232 9-pin D-sub Port Connects to the PC or the remote controller
6 RS-485 Term Switch Terminates the RS-485 if this is the only or last unit
7 Machine # DIP-switches DIP-switches for setup of the unit (1, 2 and 3 are for setting the machine
number; 4 is for RS-485 bus termination; 5 is for Reply; 8 is for RS-485 PC
communication)
8 RS-485 Port Pin G is for the Ground connection 2
9
; pins B (-) and A (+) are for RS-485
Mains Power Switch Illuminated switch for turning the unit ON and OFF
10 Mains Fuse Holder Contains the mains fuse
11 Mains Power Socket Socket for mains power cable
12 FACTORY RESET Button Press and hold while powering up the unit to reset the audio, switching and
Ethernet settings to their factory default values:
IP address 192.168.1.39
Mask 255.255.255.0
Gateway 192.168.1.1
Audio gain for all inputs and outputs 0dB
All switching configuration
Erased
Display 1, 2, 3, 4, 5, 6, 7, 8
Audio mode AFV
13 ETHERNET Connector Connects to the PC or other Serial Controller through computer networking
14 PROG Button Push in for “Program” to upgrade to the latest Kramer firmware via
RS-232, or release for “Normal” (the factory default)
15 AUDIO OUTPUTS
Terminal Block
Connectors
Connect to the balanced stereo audio acceptors
16 AUDIO INPUTS Terminal
Block Connectors
Connect to the balanced stereo audio sources
4.1 Using the IR Transmitter
You can use the RC-IR3 IR transmitter to control the machine via the built-in IR
receiver on the front panel or, instead, via an optional external IR receiver 3
1 Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (see Section
. The
external IR receiver can be located up to 15 meters away from the machine. This
4.1 )
2 The ground connection is sometimes connected to the shield of the RS-485 cable. In most applications, the ground is not
connected
3 Model: C-A35M/IRR-50