Kramer Electronics VP-460 - Manual (Page 25)

20 VP-460 - The OSD Menu
5.3 The Audio Menu
Figure 12: Audio Menu
Setting Function
Volume Set the volume level [dB], see Figure 13 E . Set the:
Input Volume [dB] – to adjust the audio input level
Output Volume [dB] – to adjust the audio output level
The output audio level can also be set via the + and – buttons on the front
panel buttons (when not in the OSD mode) and/or the IR remote control
transmitter buttons (see Section 7.3
Balance
)
Set the balance [ratio] E
Treble Set the treble [dB] E
Bass Set the bass level [dB] E
Lip Sync Set the Lip Sync delay value [msec] E
SDI Channeling Set the SDI channeling for groups A, B, C and D and connect the active
channels (see Section 5.3.1
By default, group A is connected and groups B, C and D are disconnected
) E .
Set the SDI channeling for groups A, B, C and D to: Activate CH1 or
Activate CH2
If other groups are set to Activate, the remaining groups are read as
None