SawStop CNS175-AU - Manual (Page 9)

SawStop 10” Contractor Saw 7
5. The contractor saw in its standard configuration is intended for use on a 110-120V supply circuit that has an
outlet that looks like the one illustrated in Sketch A below.
A temporary adapter, which looks like the adapter illustrated in Sketch B and C, may be used to connect this plug
to a 2 pole receptacle as shown in Sketch B if a properly grounded outlet is not available. The temporary adapter
should be used only until a properly grounded outlet can be installed by a qualified electrician. This adapter
is not permitted in Canada. The green-colored rigid ear, lug, and the like, extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box.
6. A contractor saw that has been re-wired for 208-240V power
is intended for use on a circuit that has an outlet that looks like
the one illustrated in Sketch D. The saw has a grounding plug
that looks like the plug illustrated in Sketch D. Make sure the
saw is connected to an outlet having the same configuration
as the plug. No adapter is available or should be used with
this saw. If the saw must be reconnected for use on a different
type of electric circuit, the reconnection should be made by
qualified service personnel; and after reconnection, the saw
should comply with all local codes and ordinances.
Safety
Sketch D
grounding pin
grounding
pin
Sketch A
Sketch B
cover of grounded
outlet box
metal screw
cover of grounded
outlet box
Sketch C
grounding
means
adapter
adapter
!
WARNINGS